Fit and safety: dressing a robot without getting in its way
A robot that can't see, cool itself or reach its charger won't do its job, and one that's unbalanced or snagged can become a hazard. This guide covers how to measure for a good fit and what to check every time something goes on.
Measuring a robot
Work with the robot switched off and parked on a level floor. Record its overall height and its circumference at several heights, such as the head, the widest part of the body and just above the base, since few robots are a simple cylinder.
Next, map the no-go zones. Photograph the robot from every side and mark each sensor window, camera, speaker grille, screen, vent, charging contact, port, button and service hatch. Note how far each sits from the floor at its top and bottom edge. Those are the boundaries any garment has to respect.
Before cutting good fabric, fit a mock-up made from paper or cheap calico. Adjusting a template is far easier than altering a finished piece.
If parts move, such as a rotating head, a tilting screen, a lid or a drawer, check the fit with each part in every position it can reach.
Parts that must stay clear
These are what the robot uses to sense, communicate and stay powered.
- Lidar windowsOften a band or slot that scans the room. Fabric in front of it can register as a permanent obstacle or create a blind spot.
- Cameras and depth sensorsA brim, fringe or ear can sit in the field of view without ever touching the lens.
- Speakers and microphonesFabric over a grille muffles announcements and may interfere with voice features.
- ScreensLeave the whole display and its touch area uncovered, edges included.
- Charging contactsThe robot has to line up with its dock and make clean contact. Test docking with the garment on.
- VentsMotors and batteries produce heat. Covering a vent traps it.
- Emergency stop and bumpersThe stop button must be visible and pressable, and bumpers must be free to move.
- Floor sensors and wheelsAnything underneath that watches for drops, and the drive wheels themselves, need open space around them.
Weight and balance
Service robots are designed around their own weight distribution. Adding weight up high, such as a heavy hat or a thick padded collar, raises the centre of gravity and can make the robot less steady when it brakes, turns or crosses a threshold. Ask the supplier whether added weight affects the rated payload.
Keep additions light, spread them evenly and fasten them so they can't swing. A piece that shifts on every turn changes the balance during a shift and can slide into a sensor's view.
Hems should finish well above the floor, and anything near the drive area should be held close to the body.
Pre-use checklist
Run through this each time a garment is fitted or refitted.
- Every sensor window, camera and lens is fully visible, viewed straight on and from an angle.
- The emergency stop can be seen and pressed without lifting anything.
- Screen, speakers, vents, ports and charging contacts are uncovered.
- Nothing hangs low enough to reach the wheels or floor sensors.
- Fastenings are closed, and nothing flaps when the robot turns sharply.
- Trays, lids and compartments open, close and load normally.
- A test run on the usual route shows no new stops, hesitations or detours.
- The robot docks and begins charging with the garment on.
- The garment itself is clean, dry and undamaged.
Ask before you alter
The supplier knows the robot better than anyone.
Some warranties or service agreements restrict covering, sticking or attaching things to the shell. Check with the manufacturer or supplier, especially before using adhesives or anything that clips into seams.
Once the fit is right, our sister guide on keeping robot covers clean and hygienic covers upkeep.
General information about service robots is available from RobotX at robotx.au.